Bolt Yield Strength: Risks of Tightening into the Plastic Region

Bolt Yield Strength: Risks of Tightening into the Plastic Region

When specifying tightening torques, yield strength (Re or Rp0,2) is the most important material parameter. It defines the limit up to which a bolt returns to its original length after being loosened. If this limit is exceeded, the bolt undergoes permanent (plastic) deformation, which is undesirable.

Yield strength and bolt tightening

Most industrial standards (including EN 1591-1) recommend tightening bolts to 70% to 90% of their yield strength. This value provides a sufficient safety margin against operating forces, temperature changes and vibrations. However, exceeding 100% of the yield strength is dangerous and can have several consequences.

Consequences of exceeding the yield strength

  1. Loss of elasticity – a plastically deformed bolt no longer acts like a spring and cannot respond to temperature changes. It remains permanently stretched.
  2. Reduction in cross-sectional area – as the bolt stretches, its diameter decreases, which can lead to sudden fracture.
  3. Cannot be reused – the bolt must be replaced with a new one at the next shutdown.

Effect of lubricant on exceeding the yield strength

Assembly technicians should be aware that using low-quality lubricants or lubricants whose coefficient of friction is not precisely specified can cause the yield strength to be exceeded even when the specified tightening torque is followed.

Are you ready to put your seal selection worries behind you? Contact us

and get valuable advice and information on industrial seals

Logo Pokorny Industries

Pokorny Industries Partnership in quality

All prices excluding VAT

© Pokorny industries s.r.o. 2026 - all rights reserved

Made by servisdesign