Flange leveling: when it is necessary and how it is done

A damaged sealing surface does not require part replacement or lengthy downtime. Find out what flange facing solves, how to identify a damaged flange, and how the repair is carried out on site.

Flange leveling: when it is necessary and how it is done

No gasket can seal a damaged flange. Scratches, corrosion and waviness on the sealing face are among the most common causes of recurring leaks—and replacing the gasket will never fix them. The solution is flange resurfacing: machining the face flat on site, without removing the pipework.

What flange resurfacing fixes

How to tell if the face needs repair

  1. The joint always leaks at the same point around the circumference – the imprint is fainter there on the removed gasket.
  2. A radial scratch across the width of the seating face – virtually certain to cause a leak.
  3. A straightedge and feeler gauge reveal unevenness.
  4. Corrosion that cannot be removed by cleaning.

A rule of thumb from experience: defects you cannot catch with a fingernail can be accommodated by a softer gasket (graphite, Kammprofile). Defects you can catch with a fingernail require the face to be repaired.

The repair process

  1. Assessment of the damage – extent, depth and type of face.
  2. Installation of portable machining equipment directly onto the flange, without removing the pipework.
  3. Machining to achieve the flatness and roughness required for the gasket type.
  4. Inspection and report – measurements and documentation.
  5. Joint assembly – the correct gasket, calculated torque and a guarantee.

The work fits within a planned shutdown—it takes hours to days, depending on the scope. Replacing the entire component (welding, pressure testing and inspection) takes several times longer and costs several times more.

When flange resurfacing is not enough

Damage extending below the minimum flange thickness, cracks or body deformation. The assessment will identify these too—we will tell you directly what can be repaired and what needs to be replaced.

The quickest way to get started: send us a photo of the face and the flange dimensions. We will assess it and propose a solution.

Send the flange for assessment →

What is flange resurfacing?

Machining a damaged sealing face flat using portable equipment on site. It removes scratches, corrosion and waviness.

Does the pipework need to be removed?

No. The equipment is mounted directly onto the flange.

How long does the repair take?

Typically, a few hours per joint, depending on the scope and diameter.

Can you tell in advance whether the repair will work?

Yes, by assessing the depth and extent of the damage. If replacing the component is the better option, we will recommend it.

Are you ready to put your seal selection worries behind you? Contact us

and get valuable advice and information on industrial seals

Logo Pokorny Industries

Pokorny Industries Partnership in quality

All prices excluding VAT

© Pokorny industries s.r.o. 2026 - all rights reserved

Made by servisdesign