Flange tightening procedures in accordance with EN 1591-4 and ASME PCC-1

Flange tightening procedures in accordance with EN 1591-4 and ASME PCC-1

Cross-pattern tightening, also known as tightening in a crisscross pattern, involves tightening opposing bolts. It is a basic rule for preventing uneven gasket compression and flange misalignment. During the initial stages, bolts should never be tightened one after another around the circumference.

Step 1: Hand tightening (Snug tight)

Evening out the gaps between the flanges: Tighten all nuts by hand or with a standard wrench to approximately 10–15% of the target tightening torque. Check the gaps around the circumference. The flange faces should seat against the gasket. For the following steps, divide the final tightening torque into thirds.

Step 2: Tightening to 20–30% of the total tightening torque

Cross-pattern sequence: Apply the first pass of torque tightening in a cross pattern.

Step 3: Tightening to 50–70% of the torque

Checking gasket seating: Repeat the cross-pattern sequence at a higher tightening torque.

Step 4: Tightening to 100% of the torque

Final tightening in a cross pattern: Apply the full calculated tightening torque Mₘₐ in a cross pattern.

Step 5: Circular pass to equalize the load

Eliminating elastic interaction between bolts: Tighten all bolts sequentially around the circumference to 100% of the full torque until none of the nuts turns. This procedure may need to be repeated several times. This compensates for the interaction between adjacent bolts.

Are you ready to put your seal selection worries behind you? Contact us

and get valuable advice and information on industrial seals

Logo Pokorny Industries

Pokorny Industries Partnership in quality

All prices excluding VAT

© Pokorny industries s.r.o. 2026 - all rights reserved

Made by servisdesign