K-Factor (Nut Factor): A Practical Simplification

K-Factor (Nut Factor): A Practical Simplification

Because calculating the coefficient of friction (μ) for different thread diameters and materials is complex, engineering practice (especially in the USA, according to ASME) uses a simplification called the K-factor. This coefficient accounts for friction in the threads and under the nut.

Calculation using the K-factor

The relationship is defined as M = K · D · F, where D is the nominal bolt diameter.

Limitations of the K-factor

Using the K-factor allows for a quick estimate of torque in the field. It should be emphasized that the K-factor is an empirical value and may vary depending on the quality of thread machining and the material of the washers. In the vast majority of cases, it is therefore better to perform an accurate calculation according to EN 1591-1, which distinguishes between friction in the threads and friction on the bearing surface.

Are you ready to put your seal selection worries behind you? Contact us

and get valuable advice and information on industrial seals

Logo Pokorny Industries

Pokorny Industries Partnership in quality

All prices excluding VAT

© Pokorny industries s.r.o. 2026 - all rights reserved

Made by servisdesign