Lubrication of fasteners and coefficient of friction

Lubrication of fasteners and coefficient of friction

When tightening a bolted joint to a specified torque, up to 90% of the applied energy is used to overcome friction. Approximately 50% is consumed by friction under the bolt head or nut, another 40% by friction in the thread, and only the remaining 10% is used to generate the axial bolt force (Fᵥ).

Relationship between tightening torque and axial force

Mma = FV · (0.159 · P + 0.577 · d2 · μth + Dm · μn / 2)

Effect of lubrication on friction in a bolted joint

Unlubricated steel bolts: The coefficient of friction in the thread is typically μ ≈ 0.18–0.25. This can result in a wide variation in preload and increases the risk of galling.

High-quality paste (e.g. containing MoS₂ or copper): The coefficient of friction in the thread is typically μ ≈ 0.08–0.12. This can result in more predictable preload and a higher axial force at the same tightening torque.

Assembly pastes for bolted joints must have measured friction values in accordance with EN 16047, which specifies how to measure the required coefficients of friction in the thread and under the bolt head, as well as total friction and the K-factor.

Are you ready to put your seal selection worries behind you? Contact us

and get valuable advice and information on industrial seals

Logo Pokorny Industries

Pokorny Industries Partnership in quality

All prices excluding VAT

© Pokorny industries s.r.o. 2026 - all rights reserved

Made by servisdesign