O-Rings: Dimensions, Materials, and Error-Free Installation

How to read O-ring dimensions, choose a material, and why the groove determines the design. Four installation mistakes responsible for most leaks.

O-Rings: Dimensions, Materials, and Error-Free Installation

An O-ring is the simplest sealing element in the world—a piece of rubber with a circular cross-section that can seal hundreds of bar. That is, if four things are right: the size, the material, the groove and the installation. If an O-ring leaks, one of them is to blame.

How an O-ring seals

By compressing its cross-section in the groove. The deformed rubber fills the space, and the pressure of the fluid pushes it against the sealing surface—as pressure increases, the O-ring becomes self-energizing to a degree. The key factor is cross-section compression, typically 15–30% for static applications and 10–20% for dynamic ones.

Dimensions and designation

Two dimensions: inside diameter × cord cross-section (e.g. 25×3). Measure the groove and the components, not the old O-ring—the rubber will have taken a permanent set.

Watch out for standards: metric and inch series (AS568) differ. An O-ring from another series that is “almost the same” will not seal properly.

Material: the same rules apply as for any rubber

MaterialTemperatureApplications
NBR−30 to 120 °Coils, fuels – standard choice
EPDM−50 to 130 °Chot water, steam, outdoor environments
FKM−20 to 200 °Cchemicals, higher temperatures
VMQ (silicone)−60 to 200 °Cfood applications, extreme temperatures
PTFE / encapsulateddepending on designaggressive chemicals

Compare rubber types and learn about common mix-ups: NBR vs. EPDM vs. FKM. Check chemical resistance in our database.

The groove matters more than you might expect

Four installation mistakes behind most leaks

  1. Twisting the O-ring as it is fitted – causing spiral damage.
  2. Damage from an edge or thread – without an installation cone, any sharp edge can cut the O-ring.
  3. Dry installation – lubricate with the fluid or a compatible lubricant (mineral lubricant must not be used with EPDM).
  4. Stretching beyond the limit – the inside diameter can only tolerate a few percent of stretch.

Why O-rings age

Rubber under constant compression loses its elasticity (compression set): the O-ring takes the shape of the groove instead of retaining its circular shape, and can no longer compensate for changes in temperature and pressure. That is why O-rings should be replaced whenever an assembly is taken apart—a new one costs pennies, while a leak can mean downtime.


We supply O-rings in metric and inch series, with advice on groove design and material selection.

Request O-rings →

How do you measure an O-ring?

Inside diameter × cord cross-section (25×3 mm). Measure the groove, not the old, deformed O-ring.

How much compression should an O-ring have?

Typically 15–30% for static applications and 10–20% for dynamic ones – the exact value depends on the groove design and compound hardness.

Why does an O-ring leak immediately after replacement?

It may have been damaged during installation, be the wrong size due to a different standard series, or be made from a material unsuitable for the fluid.

When should you use backup rings?

At high pressures where there is a risk of the rubber being extruded into the clearance gap – typically in hydraulic applications.

Are you ready to put your seal selection worries behind you? Contact us

and get valuable advice and information on industrial seals

Logo Pokorny Industries

Pokorny Industries Partnership in quality

All prices excluding VAT

© Pokorny industries s.r.o. 2026 - all rights reserved

Made by servisdesign