Oil Seals: Design, Selection, and Six Reasons They Leak

Types of oil seals (A, AS, C), dimension markings, selection by shaft and medium—and six reasons why an oil seal leaks. None of them sounds like “a faulty oil seal”.

Oil Seals: Design, Selection, and Six Reasons They Leak

An oil seal (radial shaft seal, simmering) is the most widely used dynamic seal of all—and a component that is often chosen on price and most frequently installed incorrectly. The result: oil under the machine and a search for someone to blame.

How an oil seal works

A spring presses the rubber lip against the rotating shaft. The sealing edge runs on a microscopic oil film—the film lubricates and cools the lip, so the oil seal must not run dry. The outer casing serves a second function: static sealing in the housing bore.

Types and markings

TypeDesignApplication
A (WA)rubber outer casingstandard; seals well in the housing
AS (WAS)type A + dust lipdusty and dirty environments
B/C (WB/WC)metal casing (C is reinforced)secure fit, heavy-duty operation

Dimensions: inside diameter × outside diameter × width (e.g. 35×52×7). Measure the shaft and housing, not the old oil seal—it will have become deformed.

Lip material: NBR up to 100 °C, FKM for higher temperatures and more aggressive media, silicone for an extreme temperature range. Rubber comparison: NBR vs. EPDM vs. FKM.

Six reasons why an oil seal leaks

  1. Lip damaged during installation – forced over a thread or groove without an installation sleeve. By far the most common cause.
  2. Worn shaft – the lip runs in a groove left by the old oil seal. Solutions: reposition the oil seal, fit a repair sleeve, or machine the shaft.
  3. Wrong lip material – the temperature or medium exceeds the limits of NBR.
  4. Running dry – installed without lubrication or started without oil.
  5. Incorrect installation – the oil seal is driven in at an angle or struck on the lip.
  6. Excessive pressure in the housing – a blocked gearbox breather. Standard oil seals can withstand only approx. 0.3–0.5 bar.

None of these causes sounds like a “defective oil seal.” The vast majority of leaks are caused by the application and installation.

Correct installation at a glance

  1. Inspect the shaft and housing bore.
  2. Lubricate the lip and shaft with the operating medium.
  3. Use an installation sleeve to protect the lip from threads and grooves.
  4. Press the seal in evenly and squarely, applying force to its outer diameter.
  5. Fit the dust lip as specified—dry or with lubricant between the lips.

When an oil seal is not enough

High peripheral speeds, pressure, abrasive media, or a zero-leakage requirement call for mechanical seals and other rotating equipment sealing systems.

Request a quote for oil seals →

What does the marking 35×52×7 mean?

An inside diameter of 35 mm (shaft), an outside diameter of 52 mm (bore), and a width of 7 mm.

What is the difference between type A and AS?

AS has a dust lip—a second lip that keeps out dirt. Choose AS for dusty environments.

Why does an oil seal still leak after replacement?

A worn groove on the shaft, a lip damaged during installation, or the wrong material for the temperature and medium.

Does an oil seal need to be lubricated before installation?

Yes—lubricate the lip and shaft with the operating medium. Starting dry will destroy the lip immediately.

Are you ready to put your seal selection worries behind you? Contact us

and get valuable advice and information on industrial seals

Logo Pokorny Industries

Pokorny Industries Partnership in quality

All prices excluding VAT

© Pokorny industries s.r.o. 2026 - all rights reserved

Made by servisdesign