Packing cord: types, selection, and proper installation

Graphite, PTFE, and aramid packing cords: how to choose based on the medium, cut and install rings, and why the packing must drip.

Packing cord: types, selection, and proper installation

Packing is one of the oldest sealing technologies—and still the most sensible choice for many applications. Most of the “faulty” packing we see in operation has simply been cut incorrectly or overtightened.

Where packing still makes sense

How it works: packing needs a controlled leakage rate to cool and lubricate it. Where leakage is not acceptable, the machine needs a mechanical seal.

Packing types by material

MaterialStrengthsTypical applications
Expanded graphitetemperature resistance, steam, chemicals; self-lubricatingpower generation, valves
PTFEchemical resistance, cleanlinesschemical, food and pharmaceutical industries
Graphite-filled PTFEresistance + lubricitygeneral-purpose pump packing
Aramidabrasion resistance, strengthabrasive media, higher pressures
Combination packing (aramid corners)strength + lubricitydemanding pump applications

Choosing packing in four steps

  1. Media and pH – PTFE for chemicals, graphite for steam and high temperatures, aramid for abrasion.
  2. Temperature and pressure – temperature is the key factor for valves; pressure in the stuffing box matters for pumps.
  3. Movement – rotation requires more lubricious packing than the slow reciprocating movement of a valve stem.
  4. Cross-section – (stuffing-box bore − shaft diameter) / 2. Measure the space, not the old packing; the wrong cross-section cannot be corrected by tightening.

Installation step by step

  1. Clean the stuffing box and inspect the shaft. A grooved shaft will destroy any packing.
  2. Cut rings, not a spiral. Cut each ring separately on a mandrel with the same diameter as the shaft, at a 45° angle.
  3. Insert the rings one at a time and rotate each joint by 90° from the previous one—otherwise a leakage path will form.
  4. Tighten the gland follower evenly and gently, in a criss-cross pattern and in small increments.
  5. Run in with leakage. Start the machine with the packing gland relatively loose, then gradually reduce the leakage. Packing tightened dry will burn out on startup.

The most common mistake: overtightening. Packing with no leakage overheats, hardens and scores the shaft—yet maintenance keeps tightening it. The result is a damaged shaft sleeve.

When to replace packing

Replace it when the leakage cannot be controlled by tightening, the gland follower is bottomed out, or leakage increases after tightening. Adding another ring to a fully tightened set is a stopgap, not a repair.

We can help you choose packing for your media and equipment—and train your maintenance team in proper installation as part of our installer training.

Enquire about packing →

What is the difference between packing and a mechanical seal?

Packing seals by compression, allowing controlled leakage, and is easy to maintain. A mechanical seal uses lapped faces to seal with virtually no leakage, but is more sensitive to the condition of the machine.

Should packing drip?

Yes, in rotating applications—the leakage cools and lubricates it. If tightened dry, it will burn out and damage the shaft.

How is the packing cross-section determined?

(Stuffing-box bore − shaft diameter) / 2. Never estimate it from the old packing—it will have become deformed.

Are you ready to put your seal selection worries behind you? Contact us

and get valuable advice and information on industrial seals

Logo Pokorny Industries

Pokorny Industries Partnership in quality

All prices excluding VAT

© Pokorny industries s.r.o. 2026 - all rights reserved

Made by servisdesign