Access to prices and online shopping
Overview of your purchased items
Contact your sales representative and clerk
Educational materials
News about industrial seals
Information on new products and services
Exclusive hints and tips
Fittings and valves are a risk area in every piping system. In the event of a sudden failure of the seal or body of the fitting, the medium escapes directly to the operator. Safeval safety collars capture the leak at the source and protect the health of workers – without restricting access to the control elements.
These values are approximate and may be influenced by other factors. We will be happy to consult with our expert to make sure you make the right choice.
Safety sleeve made of 100% PTFE, from the fabrics to the tightening cables.
Safety sleeve made of special fibreglass VETRARTE 200/C. Each fiber is impregnated with PTFE for chemical resistance.
Safeval 100% PTFE – is made exclusively from PTFE – from fabrics to tightening cords. It is resistant to degradation from aggressive media and temperature, making it the first choice for hazardous chemical operations. Operating range: −200 to 230 °C, 1–100 bar. Safeval VT – is made from special glass fibers VETRARTE 200/C, where each fiber is impregnated with PTFE for chemical resistance. Operating range: −150 to 230 °C, 1–100 bar. Both versions are available with a transparent GARD cover, which allows for visual inspection of the joint condition without disassembly. Upon request, the clamp can be equipped with drainage for diverting captured media into a collection container.
Safeval clamps fully protect the body of the fitting except for the control levers and handwheels.
Safeval 100% PTFE is made exclusively from fluoropolymer – suitable for the most aggressive chemical media and the widest temperature range (−200 to 230 °C). Safeval VT combines VETRARTE 200/C glass fibers with PTFE impregnation with a temperature range of −150 to 230 °C. Both types achieve the same max. pressure of 100 bar.
Yes – both versions are available in a transparent GARD design, which allows for visual inspection inside the fitting during operation.
The standard fitting captures the media inside. Upon request, we can provide a version with a drainage hole for discharging the media into a collection container – suitable where leak detection is necessary or where the media must not escape freely into the environment.
Installation and removal are straightforward and do not require modification of the fittings. The specific procedure depends on the type of fitting and operating conditions – we can advise if needed.
© Pokorny industries s.r.o. 2026 - all rights reserved
Made by servisdesign
You don't know what to do?
