Bolt lubrication: the cheapest safeguard for a leak-tight flange joint

Most of the tightening torque is lost to friction. Why use lubricants with a coefficient of friction measured in accordance with EN 16047, and what does a dry film do for assembly repeatability?

Bolt lubrication: the cheapest safeguard for a leak-tight flange joint

A negligible line item in the maintenance budget. In the physics of a bolted joint, one variable determines everything: friction. If you don’t control friction, you don’t control preload. And if you don’t control preload, you don’t control sealing integrity.

Why friction matters

Tightening torque is divided into three parts: thread friction, friction under the nut, and useful preload. Friction accounts for around 90% of the torque.

The result: a small change in the coefficient of friction means a large change in preload. The same bolt, the same torque—but dry, rusty, or lubricated with “something off the shelf”—produces a different joint every time. Variation of tens of percent, in either direction. More than enough to leave a gasket under-tightened or crush it.

The coefficient of friction is also an input to every torque calculation. A calculation based on estimated friction is a calculated roll of the dice—which is why the procedure always specifies which lubricant the torque value applies to.

What EN 16047 says

The standard defines how the coefficient of friction in bolted joints is measured—in the threads and under the nut, under defined conditions. A lubricant “with values according to EN 16047” means the manufacturer has documented the friction achieved with that lubricant, and you can use that value in your calculation.

Workshop grease offers none of this: you don’t know the friction, it changes with temperature and time, and at higher temperatures it runs off or carbonizes.

Why dry lubricants

For flange joints, we apply dry lubricants with measured coefficients of friction. Compared with pastes and greases, they offer:

Principles for lubricating fasteners

  1. Lubricate both the threads and the nut bearing surface – friction acts in both places.
  2. Be consistent – use the same lubricant and apply it in the same way to every bolt. Mixing lubricants leads to uneven gasket compression.
  3. Never lubricate the gasket – a legacy of the asbestos era (habits from the asbestos era).
  4. Record it in the procedure – a torque value without the specified lubricant is incomplete information.

The cheapest item with the greatest leverage

Torque wrenches, calculations, training—all cost money. A defined lubricant is a negligible expense that makes the rest of the system worthwhile: without controlled friction, even a perfect calculation is just a number on paper. At installer training courses, lubrication is often the course’s biggest lightbulb moment.

Enquire about lubricants with measured friction →

Why lubricate bolts before tightening?

Friction consumes most of the torque. Without a defined lubricant, preload is unpredictable—the joint may be either under-tightened or over-tightened.

What is EN 16047?

A standard for measuring the coefficient of friction in bolted joints. Lubricants with measured values allow accurate torque calculations.

What should you use to lubricate flange joint bolts?

A lubricant with a measured coefficient of friction—typically a dry, temperature-stable lubricant for industrial joints.

Can the gasket itself be lubricated?

No. Lubricant belongs on the threads and under the nuts.

Are you ready to put your seal selection worries behind you? Contact us

and get valuable advice and information on industrial seals

Logo Pokorny Industries

Pokorny Industries Partnership in quality

All prices excluding VAT

© Pokorny industries s.r.o. 2026 - all rights reserved

Made by servisdesign