Installation practices from the asbestos era: why they cause leaks today

Tighten it “as tight as you can,” grease the gasket with petroleum jelly, and don’t bother lubricating the bolts. Maintenance habits from the asbestos era are still passed down today—and they consistently fail with modern gaskets.

Installation practices from the asbestos era: why they cause leaks today

Asbestos gaskets have been banned for decades. But the methods used to install them live on – passed down through maintenance teams as “proven practice” and responsible for many of the leaks we deal with. We see it regularly in our training courses: the hands of a young fitter, following the habits of his predecessor from the 1980s.

Why asbestos forgave everything

Asbestos was dimensionally stable, could withstand enormous overloads and forgave any installation method. Bolts tightened “as hard as you can”, gaskets greased with petroleum jelly to keep them in place – and no one gave a second thought to washers or bolt lubrication.

It worked. Not because the method was right, but because asbestos could take the mistakes.

Modern materials – compressed fibre, expanded graphite, PTFE – have precisely defined properties: enough pressure to seal, but less than the destruction limit. With these materials, methods “from the asbestos era” don’t provide a safety margin. They cause damage.

Four inherited habits

1. “Tighten as hard as you can”

A safe strategy with asbestos, but destructive with modern materials. Overloading crushes compressed fibre; with PTFE, excessive pressure accelerates cold flow and the joint loosens in service. Every gasket used today has a specified maximum surface pressure – and it’s easy to exceed it with ordinary tools.

Today: tighten to the calculated torque – see bolt tightening torques) and torque calculation.

2. “Grease the gasket so it stays in place”

Petroleum jelly held asbestos gaskets in place during installation. On a modern gasket, it changes the friction against the flange and reduces resistance to blowout.

Today: gaskets must be installed dry and clean. Use the correct method, not grease, to centre them.

3. “Lubricating bolts is pointless”

Quite the opposite – it’s the cheapest insurance against leaks. Friction in the threads and under the nut consumes most of the torque; without a specified lubricant, bolt preload is a lottery. Read more: Bolt lubrication according to EN 16047).

4. “Washers? They just slow you down.”

Washers distribute the pressure under the nut and stabilise friction. Without them, it’s even harder to convert torque into preload. When and why: washers in bolted joints).

The problem isn’t the people, it’s the system

Experienced fitters are leaving, and with them the feel that partly made up for missing procedures. The next generation inherits the “how”, but not the “why”.

The solution: specified torques for critical joints, defined lubricants, procedures – and training that gives fitters the context behind the practical work. That’s exactly what our fitter training according to EN 1591-4 covers. The standard was created precisely to bring order to gasket installation in the post-asbestos era. More than 800 fitters from over 60 companies have completed our training.

Book fitter training →.


FAQ

Why were asbestos gaskets installed differently?

Asbestos could withstand overloading and careless installation. Modern materials have defined limits and require calculated torque and clean installation.

Can modern flat gaskets be lubricated?

No. Lubricant belongs on the threads and under the nuts, never on the gasket.

What’s the biggest mistake when installing a flanged joint?

Tightening without a specified torque – that’s how 95% of the fitters who attend our training work. The second most common mistake: bolts that aren’t lubricated.

Are you ready to put your seal selection worries behind you? Contact us

and get valuable advice and information on industrial seals

Logo Pokorny Industries

Pokorny Industries Partnership in quality

All prices excluding VAT

© Pokorny industries s.r.o. 2026 - all rights reserved

Made by servisdesign