95% of installers tighten “by feel.” What data from 800 training sessions revealed

We have trained over 800 installers from 60 companies. 95% of them have no specified tightening torque for the installations they carry out. What does this mean for leak-tightness and operational safety?

95% of installers tighten “by feel.” What data from 800 training sessions revealed

Since 2015, more than 800 flange joint installers from over 60 companies have attended our training center. One statistic from these training sessions should concern every maintenance manager: 95% of installers do not have a specified tightening torque for their work. They tighten by feel.

What “by feel” means in numbers

Feel cannot be measured, transferred or checked. The preload of a bolt tightened without a torque wrench commonly differs from the required value by tens of percent—in either direction.

For a cooling-water joint, that means dripping water. For a critical joint—one whose failure puts personnel, equipment or the environment at risk—it means a safety hazard.

Inherited practice, not negligence

Installers are not the problem. They inherited practices from an era when asbestos gaskets could tolerate anything (Assembly practices from the asbestos era..). In most companies, a system of specified torques and records was never established.

One telling detail: a significant proportion of participants first learn during training that lubricating bolts fundamentally changes the relationship between torque and preload—and that without a specified lubricant, even the correct torque is only approximate.

Three steps to put things right

1. Specify torques for critical joints. Not “for the bolt” tables, but calculated torques for a specific joint.. Start with joints whose failure would have serious consequences critical joints.

2. Give installers the tools and rules they need. Torque wrenches, specified lubricants EN 16047, and assembly records. Without a record, there is no way to verify the work.

3. Train and certify them. The EN 1591-4 standard defines the qualification of personnel assembling bolted joints in pressure equipment: 27 topics, from materials, lubrication and tightening to leak detection. The standard aims to make assembly a skilled profession, like welding. Our training in accordance with EN 1591-4 provides certification by a body accredited by the Czech Accreditation Institute (ČIA); the certificate is valid for 5 years.

In addition to the requirements of the standard, we teach tightening by gasket deformation—a checking technique for situations where the installer has no torque value and feel is all that remains. If you have to rely on feel, at least make it calibrated.

A question for maintenance managers

How many of your critical joints have a specified torque—and how many were actually tightened to that torque, with a record? If you don’t know the answer, you’re among the 95%.

Book installer training →

What is tightening “by feel”?

Tightening without a specified torque or a torque wrench. The actual preload can then differ by tens of percent.

What is EN 1591-4?

A standard for qualifying personnel who assemble bolted joints in pressure equipment for critical applications. It defines the training content and certification, which is valid for 5 years.

Who is the training for?

Bolted-joint mechanics, supervisors and responsible engineers—as specified in Tables 1 and 11 of the standard.

Is training installers enough?

Training is one of three requirements. Without specified torques and defined lubricants, installers have nothing to follow.

Are you ready to put your seal selection worries behind you? Contact us

and get valuable advice and information on industrial seals

Logo Pokorny Industries

Pokorny Industries Partnership in quality

All prices excluding VAT

© Pokorny industries s.r.o. 2026 - all rights reserved

Made by servisdesign